CrimeStopper SP-302 Instruções de Operação descarregar pdf (Página 4)

USING THE 2-WAY PAGER TRANSMITTER

The 2-Way LCD Pager remote transceiver is used to send and receive information from the vehicle. The Control

Module transmits High Frequency FM signals from the vehicle to your pager over long distances. Your range

will vary depending on location, terrain, and local RF noise/interference. This system is not guaranteed to page

you if you are behind concrete walls, underground, in a large structure, or in an area with high levels of

electronic interference. Handle the pager/remote with care. The LCD display and/or the electronics may be

damaged if subjected to abuse.

BATTERY CHARGING

The 2-Way LCD remote has a battery charge indicator on top right corner of display. The battery voltage

affects the distance of the remote control. The system comes with a standard Mini USB charging cable

that plugs into the side of remote control. To access to USB plug, slide the cover to the left shown

below.

SETTING THE CLOCK (2-WAY- LCD REMOTE)

1. Press VEH Button on the side of the remote control 5 times.

2. The remote will beep and the AM or PM display will begin flashing.

3. Press the Trunk Button to go to the next item – AM - PM - Hour- Minutes.

4. Press the Lock Button to Increase time.

5. Press the Unlock Button to decrease time.

6. Press the PANIC Button to Disable or Enable Beep and Vibration. See next page.

7. Press the VEH Button to Save and Exit Setup or wait 8 seconds, the LCD light will turn off.

USB Charging Port

1 2 3 4 5 6 7 8 9 ... 15 16

Sem comentários

CrimeStopper SP-302 Instruções de Operação Página 4