CrimeStopper FS-99 Guia de Instalação descarregar pdf (Página 11)

WIRING: 18-PIN Connector Cont.

VIOLET: (+) Door Trigger Input – Zone # 5

Same as the GREEN wire below except this wire is used for vehicles that show a positive voltage (+12 volts) when

the door is open and a ground when doors are closed as in many Ford, Lincoln, and Mercury vehicles.

GREEN: (-) Door Trigger Input – Zone # 5

Identify the wire that reads ground when any door is open and 12 volts when all doors are closed. Some vehicles

may have isolated door triggers. In this case you may need to run additional wires from other doors or go directly to

the wire that triggers the vehicle’s interior dome light. Sometimes newer vehicles contain a separate body control

module (BCM) where the door trigger circuit can be located. Most vehicles will NOT require the use of BOTH Green

and Violet door trigger wires.

BLUE: (-) Trunk Trigger Input – Zone # 4

Input trigger for a grounding trunk pin switch. Connect to existing trunk pin switch that read ground when open. If no

existing switches are available, install new pin switch if desired. Note: DO NOT mount new pin switches in water

pathways.

PINK: (-) Start Activation or (+ or -) Diesel Glow Plug

The function of this wire is programmable option # 18.

• (-) Start Activation Input: This wire allows an outside source or accessory to activate a Remote Start. A

momentary ground pulse on this wire will trigger a remote start. Default

• (+ or -) Glow Plug circuit using the Pink input wire. When this wire is used, the system will wait until light turns

off before engaging the starter.

• Fixed 15 second delay (pink wire not used). Most new vehicles have a computer controlled wait to start circuit.

There is no wait to start wire, only an indicator light on the dash that is not accessible. These vehicles require

a fixed time delay for remote starting.

WHIT/RED: TACH INPUT

When installing this system in TACH REFERENCE mode, this wire must be connected to a valid source of AC

voltage. This wire allows the unit to sense the engine running. This is the most reliable method for remote starting.

See Tach Reference Section on Page 22 for more information.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Sem comentários

CrimeStopper FS-99 Guia de Instalação Página 11