CrimeStopper FS-99 Guia de Instalação descarregar pdf (Página 30)

PROGRAMMABLE OPTIONS Cont.

18. PINK WIRE SELECTION:

This option is used to change the function of the Pink wire.

There are 4 choices for this option:

1. (-) Start Activation - Default. This wire allows an outside source or accessory to activate a Remote Start. A

momentary ground pulse on this wire will trigger a remote start.

2. 15 Second Delay - Provides a solution for diesel vehicles without having to connect to the Glow Plug “Wait to

Start” input. This may be due to a variety of reasons for example: If your vehicle does not have a “Wait to Start

Circuit” or you cannot locate and identify the circuit.

3. (+) Glow Plug – Pink Input Wire must be connected to a positive “Wait to Start Light” (120 second max delay).

4. (-) Glow Plug – Pink Input Wire must be connected to a negative “Wait to Start Light” (120 second max delay).

19. MINIMUN STARTER CRANK TIME: Default = 0.8 seconds

This option controls the Minimum Starter Cranking time. This does not affect maximum crank time. This can be

adjusted in 0.1 second increments Up or Down from 0.5 to 3.6 seconds. The starter can still crank up to 3.6 seconds

with a 0.8 setting, depending on Tach reference. NOTE: The 2-Way remote control will confirm the starter crank

time on top right corner of display.

TIMED START: Use Hybrid Mode (option 1-4) to set a fixed crank time. Option 19 is used to change the crank time.

Please Note: In Hybrid Mode there is only 1 start attempt and the ignition is left on.

20. DOOR LOCKS:

This option sets how the door lock circuit works. There are 4 choices:

1. 0.8 Second Lock and Unlock - Default.

2. 3.5 Second Lock and Unlock - For older European vehicles that require a long lock and unlock pulse to

operate Vacuum door lock systems.

3. Double Unlock – This feature may be required to interface with a factory alarm or keyless entry system. The

first pulse disarms the factory alarm; the 2

pulse unlocks the doors.

4. “Wake Up” pulse on Unlock - 0.8 second unlock with Ignition pulse to wake up a BCM. This is also called

“SLAM LOCK” This feature may be required to interface with a factory alarm or keyless entry system.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Sem comentários

CrimeStopper FS-99 Guia de Instalação Página 30